To operate a DC load incorporating the use of proximity sensor and timer circuit
Components
Relay
.png)
DC Load
Timer
PNP Sensor
Supply
Control circuit
.png)
.jpg)
C.jpg)
.png)
.png)
Power circuit
.png)
.png)
Instructions
1. Click on the Control Circuit button in Control Circuit Section.
2. Get the required components in Control Circuit Section by clicking on components displayed in Components Section.
3. Establish the connections according to the control circuit diagram provided in Fig. (a).
4. Verify the control circuit by clicking on the Check Connections 1 button.
5. If Wrong Connections then click on Delete Connections 1 button to delete connections and make the right connections .
6. Once the Control Circuit is verified, switch to the Power Circuit Section , Choose between AC Load & DC Load .
7. Get the required components in Power Circuit Section by clicking on components displayed in Components Section.
8. Make the connections according to the Power Circuit diagram provided in Fig. (b).
9. Click on the Check Connections 2 button to validate the Power Circuit.
10. If Wrong Connections then click on Delete Connections 2 button to delete connections and make the right connections .
11. Once the Power Circuit is verified, switch On the Power Supplies.
12. Now set the Timer value (between 1-30sec) by rotating the timer knob.
13. Then drag the Coin on the PNP proximity sensor to start the motor with timer countdown (motor stops when countdown ends) .
14. Click on the Print button to get a print of the webpage.
15. Click on the Reset button to refresh the webpage .
[🔴 Red Endpoint Denote Positive terminal.]
[🔵 Blue Endpoint Denote Negative terminal.]
